Stone Age Fuzz
Vintage Fuzz
Are you a Fuzzy lover? Because we are in love with Fuzz effect, we made Stone Age Fuzz. Fuzz such as tone bender, 67 Marshall’s Supa Fuzz, and of course the legendary Fuzz Face revived through Stone Age Fuzz. We took the challenge to create silicon fuzz that sounds like a germanium one. Through endless experimentation, we found out that no expensive and rare NOS Germanium transistors is needed for the well-known fuzz tone. The next step was to make it enough versatile that it can adapt to any style or rig setup. With the addition of Bass and Voice control you can find the all lost fuzzy civilizations of the Stone Age music.
Bass increase or decrease your input Bass to really change the body and bottom of your instrument and Voice is a middle sweep to set up the character of your Fuzz. With the right combination of Bass and Voice you can sweep through the Fuzziest Stone Age tones.
Demo Video & Audio Samples
Photo Gallery
Controls
-
1. Volume - Boost or Cut 20dB at 6,3KHz approximately.
The center position is flat. -
2. Fuzz - Boost or Cut 20dB at 100Hz approximately.
The center position is flat - 3. Bass - Boost or Cut 15dB. The center position is flat
- 4. Voice - Sets the Middle frequency from 240Hz to 5KHz. The center position is approximately at 1KHz.
Tech Specs
Measures:
7.5 x 12 x 5.6 cm / 2.9 x 4.7 x 2.2 inches with knobs and everything
Current Draw:
2mA
Input Impedance:
500KOhm
Output Impedance:
<10KOhm
Switching
This device is true bypass. Audio will pass without power.
Power
This device takes a standard 9 volt DC power supply with a 2.1mm negative center barrel. We always recommend pedal-specific, transformer-isolated wall-wart power supplies or multiple isolated-output supplies. Pedals will make extra noise if there is ripple or unclean power. Switching-type power supplies, daisy chains and non-pedal specific power supplies do not filter dirty power as well and let through unwanted noise. DO NOT RUN AT HIGHER VOLTAGES!